Qlogic SANsurfer FC/CNA HBA CLI Guida Utente

SANsurfer FC/CNA HBA Command Line Interface (CLI)QLogic Corporation. All rights reserved.Table of Contents1.Package Contents2.Requirements 2.1 Hardwar

8. Contacting Support Please feel free to contact your QLogic approved reseller or QLogic Technical Support at any phase of integration for assistance

1. Package Contents SANsurfer FC HBA Command Line Interface (CLI) installation packages available for the supported OS platforms include the following

● About 7 MB disk space2.2 Software RequirementsSANsurfer FC HBA CLI requires the following minimum software:● QLogic QLA2xxx drivers for your

LinuxOperating Systems OS Name OS Type Hardware PlatformRed Hat RHEL AS 3.0 32-bit, 64-bit Intel x86 Intel 64, AMD64Red Hat RHEL AS 4.x 32-bit, 64-bit

6. Additional Notes This section provides additional information according to operating system (OS):6.1 General (Applies to All OSs)Two different meas

● The QLC driver does not support selective LUN configuration. 7. Known Issues and Workarounds This section describes the known issues and workaro

● HBA beacon● Target / LUN listWorkaround: None7.2 Linux7.2.1 Information Left After Deleting Persistent ConfigurationIssue: Deleting the pers

7.2.5 Warning Messages on StartupIssue: When launching SANsurfer FC HBA CLI, the following warning messages may appear on the console:qla2xxx 0000:01

Workaround: NoneTIP: When writing scripts, use the adapter WWPN instead of adapter number. 7.4.2 Unable to Save ConfigurationIssue: Under Mac OS X, no